Slide parts
Model 82     Centurion II     Centurion
Wisner's TPA  conversion to fit a Centurion II & Model 82, utilizing our Centurion slide assembly, PLUS  our TPA conversion carrier, without a slot in the bottom as shown in the above picture
Centurion slide assembly   Broken bar on a Patrician slide assembly

It is about impossible to recreate the stamped out slide bar units for the Centruion II & model 82 without making expensive stamping dies.  The Japanese factory scrapped these dies when Weatherby discontinued these models.   The Centurion hammers are different & ride higher than the later models because of the construction of the tie together of the bars to the carrier.  We have found by not machining the slot for the Centurion hammer on our carrier units that we can then use a Centurion slide assembly AND our TPA brand conversion carrier & get your later models, (Centruion II & model 82s) back into service.