STEVENS "FAVORITE"
RIFLES
Actual load times may take a while as these scanned pictures may be large, &
depending on the speed of your computer & server
| Stevens model 1894 |
![]() |
There are 4 different early Stevens Favorite models made, the
earliest, the Sideplate model, then 1889, the 1894 & the 1915. Then in
1971 Savage came out with a Stevens Favorite commemorative model 71 &
then in 1972 the model 72, (same gun, different barrel) which was a look alike
to the early guns, but no internal parts were interchangeable with the early
guns. Early 1999 saw the factory re-introduce a slightly different
Favorite yet, which was designated the model 30G

In the above Illustration we have tried to utilize known factory parts numbers off the commonly seen 1915 drawing & then renumber the above for the 1894 to be somewhat compatible between the 3 different main models, by using the same numbers where the parts are the same. And by adding either an "A", "B", or "C" to designate if there is a difference between the different model versions. The above numbers therefore may have suffixes that are not be the actual factory parts numbers, but they are what we use to avoid confusion.
The above model 1894 will not have any model markings & then some variations especially in the extractors & also transition guns have been noted. This model was made over the longest time when special orders were accepted. It could have had possibly 4 different extractors, depending on vintage. The only real way to tell which extractor you need, (IF YOURS IS MISSING) is to measure the slot in the barrel & the slot in the breech bolt.
Parts shown in RED
bold letters
are
the parts that we currently make & have for sale.
All other numbers are for
identification purposes only.
| Part # |
Nomenclature |
. | Part # |
Nomenclature |
| #1B-1 | Breech Bolt (.250 wide slot) uses 13B-1 Ext. | . | #19 | Link Pin, Upper |
| #1B-2 | Breech Bolt (.250 wide slot) uses 13B-2 Ext. | . | #20B | Link |
| #1B-3 | Breech Bolt (.250 wide slot) uses 6-9 Ejec/Ext. | . | #21B | Link Pin, Lower |
| #2B | Breech Block Pivot Screw | . | #25B | Mainspring Screw |
| #6-9 | Ejector/Extractor Assy, 22RF (new style) .250 wide | . | #27B | Take-Down Screw Assembly |
| #10B | Firing Pin | #28 | Trigger | |
| #11 | Firing Pin retainer Pin | . | #29B | Hammer Screw |
| #12B | Mainspring | . | #30 | Trigger Spring |
| #13B-1 | Extractor (Old Style .160 wide base, .240 top) | . | #31 | Trigger Spring Screw |
| #13B-2 | Extractor (.200 wide full length) | . | #36A | Tang Stock Screw |
| #14B | Frame | . | . | . |
| #15B | Hammer | . | . | . |
| #16B | Trigger Screw | . | #5 | Dummy Screw |
| #18 | Finger Lever Bushing | . | #10?? | Screw for tang sight |
| #19B | Finger Lever Screw | . | #35B | Fore-end Screw |
This gun actually had model numbers of 17, 20, & 27
assigned to it.
But the only reference to these models was on the sales catalogs & not on
the guns themselves. These model numbers referred basically to different barrel
configurations.
STEVENS FAVORITE Model 1915

The Above illustrations taken from Frank de Haas Single Shot Rifles & Actions book with the numbers changed to match factory part numbers
This
gun will have 1915 stamped on the upper tang behind the hammer
Parts shown in RED
bold letters
are
the parts that we currently make & have for sale.
All other numbers are for
identification purposes only.
| Part # |
Nomenclature |
. | Part # |
Nomenclature |
| #1C | Breech Block | . | #20C | Link |
| #2C | Breech Block Screw | . | #21 | link pin |
| #3 | Butt Plate, Rubber | . | #22 | Mainspring |
| #4 | Butt Plate Screw | . | #23 | Mainspring Plunger |
| #5 | Dummy Screw | . | #24 | Mainspring Plunger Seat |
| #6-9 | Ejector Assembly, 22RF | . | #25C | Mainspring Plunger Screw |
| #10C | Firing Pin | . | #26 | Mainspring Plunger Pin |
| #11 | Firing Pin Pin | . | #27C | Take-Down Screw |
| #12 | Fore-end (complete) | . | #28 | Trigger |
| #14 | Frame | . | #29C | Trigger Screw |
| #15C | Hammer | . | #30 | Trigger Spring |
| #16C | Hammer Screw | . | #31 | Trigger Spring Screw |
| #17C | Lever | . | #32 | Front Sight, Gold Bead |
| #18 | Lever Bushing | . | #33 | Rear Sight, Sporting (complete) |
| #19C | Lever Screw | . | #34 | Rear Sight Step only |
| . | . | . | #35C | Fore-end Screw |
| . | . | . | #36A | Tang Stock Screw |
For prices of parts that we do make for this model, click here for Link to Stevens Favorite parts
All information appearing on this page, Copyright © 1996-2006 Wisner's Inc.,
with credit given for original illustrations.
All Rights Reserved
Back
to Exploded Views
Originated 11-23-04 Last updated 12-17-2006
LeeRoy Wisner